increment load

英 [ˈɪŋkrəmənt ləʊd] 美 [ˈɪŋkrəmənt loʊd]

网络  增量载入

计算机



双语例句

  1. Under the conditions of given initial mid-span deflection, the cable length increment and load increment were obtained by means of the mid-span deflection increment.
    在给定初始跨中挠度的条件下,利用跨中挠度增量值求得索长增量值与载荷增量值;
  2. The limit state equations of main failure modes are formulated by the increment interval load method.
    并提出用区间增量载荷法生成主要失效模式的极限状态方程。
  3. By Changchun middle school elite middle distance runner increment load test, we get the maximum oxygen uptake and anaerobic threshold and the corresponding speed, heart rate.
    对长春市中学优秀男子中长跑运动员进行递增负荷测试,得到其最大摄氧量和无氧阈及其对应的速度、心率。
  4. A variable so related to another that for each value assumed by one there is a value determined for the other. To each increment of load they respond with a definite change of stress and deformation.
    应变量,函数一个与他量有关联的变量,这一量中的任何一值都能在他量中找到对应的固定值对荷载的每个增量,应力的变形都有确定的变化。
  5. To each increment of load they respond with a definite change of stress and deformation.
    对荷载的每个增量,应力的变形都有确定的变化。
  6. The analysis is performed iteratively for each increment of external load.
    对每个外载荷的增量迭加进行分析。
  7. The power expended by the internal: resistance of the Thevenin's Generator equals the increment of power expended inside the network when the load is connected.
    戴维南发电机内阻所消耗的功率,等于负载接人时网络内部损耗功率增加值。
  8. The increment ratio of load bearing capacity increases with the increment of the confinement index ratio;
    承载力提高率随着约束指标比的增加而增加;
  9. The increment of train load, speed and density in China is accompanied by an increment of train derailment accident.
    随着我国铁路列车重量、速度、密度的提高,列车脱轨事故也有所增多。
  10. The results show that the smoke velocity at the fire point and in the area behind the fire point increases significantly from 2 min to 8 min after ignition. The increment of velocity varies with forced ventilation and fire load.
    试验结果表明,点火后,隧道内火区、火区下游烟流速度在2~8min内增加很快,明显大于点火前风速,且其增幅随通风风速、火灾规模的不同而变化。
  11. The study demonstrates that the section strain along the width is nonlinearly distributed and that the effect of the shear lag is not constant and changes with the increment of the load.
    试验表明,截面应变沿宽度方向呈非线性分布,剪力滞效应随荷载的增加而变化,并不是常量。
  12. The increment ratio of load bearing capacity due to CFRP increases nearly linearly with the increment of CFRP tube confinement index;
    CFRP对圆钢管混凝土轴压短柱承载力的提高率近似随着CFRP筒约束指标的增加而线性增加;
  13. The stress strain relationship in different principal stress load direction can be reflected in the anisotropy of tangent elastic ratio or strain increment in load direction induced by unit stress increment in load direction.
    不同主应力加荷向的应力应变关系各向异性可以反映在切线弹模以及加荷向单位应力增量引起的加荷向应变增量的差异中。
  14. The analyses of overloading and non-uniform distributed load show that the fatigue lives of asphalt pavement decrease rapidly for the increment of load and non-uniform distribution of load resulted from overload.
    此外,本文还分析了车辆超载和荷载非均布的影响:随着荷载的增加,再加上车辆超载造成的荷载非均布,沥青路面的疲劳寿命下降很快。
  15. On the basis of experimental investigation, an empirical model of the relation between the increment of fatigue strength due to low amplitude load strengthening and the critical load of transmission gears is worked out.
    在试验研究的基础上拟合出汽车传动系齿轮在经受低幅交变载荷锻炼后,疲劳强度增长规律与临界载荷关系的经验模型。
  16. This paper presents a numerical method called the finite strip plasticity coefficient increment initial stress method for sloving the ultimate load of elastic-plastic stability of steel columns. Step loading and finite strip principle are employed to establish the incremental equilibrium equation of structures.
    本文提出了有限条塑性系数增量初应力法,用于分析钢压杆的弹塑性稳定极限承载力.该法采用分级加载,用有限条法建立结构的增量平衡方程;
  17. Introducing load increment factor in applied loads, the load increment of the whole loading history can be controlled to improve the quality of solutions.
    在荷载增量向量中引入荷载增量因子,就可以通过控制荷载增量因子来控制结构的整个加载历程。
  18. The Compare Increment Load Method with the Many Time Independent Load Method
    增量法与多次独立加载法的比较
  19. The paper put forward a method of stress increment under the action of load according to stress and stress characteristic of outside prestressed concrete simple support beam.
    本文针对体外预应力混凝土简支梁的受力、变形特点,提出了利用能量变分原理计算荷载作用下正常使用阶段体外索中应力增量的方法。
  20. Finally, the authors point out that under the increment of difference between the peak load and valley load in recent years, tightening up the DSM and peak load shifting are very important to improve the profits of power supply enterprises.
    最后指出,在近年来峰谷差增大的情况下,加强需求侧管理,实行削峰填谷对于提高供电企业效益是非常重要的。
  21. The transfer procedure is useful in adaptive finite element analysis for the simulation of excavation process, the elastoplastic iteration of increment load, and other calculation problems of loading step by step.
    所述传递过程,能为自适应有限元模拟多步骤开挖及弹塑性增量荷载分析等各种分步加载计算问题的解决提供有利条件。
  22. Using Equal Increment Load Flow as the Initial Value of Optimal Load Flow
    用等微增率潮流为最优潮流赋初值
  23. The results show that the friction coefficient of the steel in dry sliding friction decreases with increment of load and speed.
    结果表明,摩擦系数是随着法向载荷和滑动速度的增加而降低。
  24. By using the method of increment of load control adaptive time step, I expound the relationship between molding roller and the profiles of the velocity, analyzed the forming roller track and finished finite element modeling of the automobile longitudinal beam of variable cross-section roll-forming.
    应用载荷增量控制时间步长自适应的方法,给出了成型辊与型材之间的速度关系,分析了成型辊的轨迹,实现了汽车变截面纵梁变截面辊弯成型的有限元建模。
  25. With the whole performance of aero-engine increment, the thermal load of bearing chamber at principal axis fulcrum become large.
    随着航空发动机整机性能的提高,主轴支点处的轴承腔热负荷也逐渐增加。
  26. In this paper, two method are introduced: the increment method to load four points pure bending moment and Multi-Point Constraint.
    先提出两种计算方法:增量法施加的四点纯弯曲和多点约束法。
  27. In recent years, with the increment of engineering constructions, the load effect of cyclic traffic, earthquake and waves puts forward new challenges to the engineering anti-earthquake design in loess area.
    近年来,随着黄土地区工程建设的日益增多,复杂初始应力状态下的循环交通荷载、地震荷载以及波浪荷载等作用对黄土地区工程抗震设计提出了新的挑战。
  28. With the increment of exterior load, the largest displacement of silty surface and the obliquity of cylinder both increase in the two models, and the elastic-plastic model makes those aggrandize more quickly.
    两种模型中,随着外部荷载的增加,泥面最大水平位移和圆筒转角均增加,并且弹塑性模型增加的更快。
  29. In the optimization model, the power increment direction is constrained by the extent of load power factor to have more practical significance.
    优化模型中,将负荷功率因数的范围,作为负荷增长方向的约束条件,使计算结果更具实际意义。